For S-dizayn Toyota Corolla Chrome Door Side Molding 4 Pieces 2019 Onwards

S-Dizayn Toyota Corolla Chrome Door Side Molding 4 Pieces 2019 Onwards Notice: On vehicles without a door trim, the side door sections should be attached to the vehicle's bodywork. It is installed. Vehicle-Specific Chrome Accessory Product features: Chrome products are molded specifically for the part of the vehicle where they will be applied. is produced. Chrome products are produced from class A 304 quality stainless steel. The products can be mounted with high quality double-sided acrylic tape on the back. It is sent ready-made. Guarantee : Stainless steel bright chrome products; 5 year warranty against rust included.Installation Instruction: Install in a dry and dust-free environment. After removing the product from its packaging, use the protective double-sided tape on it. Be sure to perform assembly exercises on the area where it will be applied without dismantling the surface. Apply a cleaning liquid (alcohol, spirit, cellulosic thinner) to the surface to which the product will be bonded. etc.) thoroughly. (Additives such as perfumed cologne, wet wipes, gasoline, etc.) (Do not clean with liquids containing substances) Cleaning the floor is very important for installation. It is important. It has an oily and shiny surface such as glass seal and door protection strip. cleaning until this soil on the plastic parts disappears. is required. If the product contains an adhesive strengthening "Primer" wipe (primary: It is a chemical liquid to be applied to plastic surfaces. (cannot/should not be used on surfaces) should only be applied to the surface you have cleaned. Apply it to the area on the back of the product where the tapes will stick and the product will cover it. (Be careful not to apply it to parts where the product will not stick/cover) environment to show the full feature of the double-sided tape on the back of the product. temperature must be above 25C. After removing the protective surface of the tape hair dryer etc. to increase the adhesion force. heat to the band with the help of Apply. After removing the protective surface of the tape on the back of the product and applying heat, Apply to the cleaned and, if necessary, primed area at once. Dry Make sure it adheres well by applying pressure with a cloth. The product is solid To ensure proper adhesion, protect it from water for 24 hours and pressurized water for 48 hours. Be careful not to wash your vehicle.Chrome Auto AccessoryThis ad is listed with Entegrapi!