For Vw Volkswagen Taigo 2022 2023 2024 2025 ;And Above Years Chrome Rear Bumper Upper Protection S.Steel

Assembly Instruction: 1) Install in a dry and dust-free environment. 2) Before assembling, try the double-sided tape on the product in the area where it will be applied without removing its protection. 3)The ambient temperature during installation should be between 15°C and 35°C. If the ambient temperature is below 15°C, dry the surface with a hair dryer etc. Install by heating with . 4) Clean the surface to be bonded meticulously with a cotton cloth, rubbing alcohol or pure alcohol. After cleaning the surface to be bonded, protect it from dust and oil. DO NOT clean the surface to be bonded with oily or additive substances such as wet wipes, water, thinner, gasoline, diesel fuel or cologne. 5) After cleaning the surface to be bonded, wait 5 minutes and then start the bonding process. 6) Remove the protective surface of the double-sided tape on the product and assemble it, starting from the oval and closed surface. 7) During the assembly process, pat the product with a soft cloth or fingertips to make it fit. Press on the part for a minute and again with a hair dryer etc. Apply heat using . PLEASE NOTE: Since the tape used will show its full properties within 24 hours, use the glued part carefully during this period. To prevent the glued part from loosening, tape it with paper or packaging tape that you can remove after 24 hours. Be careful not to wash your vehicle within 24 hours. WE WISH YOU HAPPY SHOPPING...